Learn Watch Repair

Learn Clock Repair

Learn Lathe Lesson 1 (Turning)

Learn Lathe Lesson 2 (Making Jigs & Fictures)

Back to my Clock, Watch and Lathe Courses


Sherline Milling Collets, P/N 3087-3098

P/N SIZE WT. PRICE
3087 3/32" .05 lb. $15.00
3089 5/32" .05 lb. $15.00
3091 7/32" .05 lb. $15.00
3092 3.0 mm .05 lb. $15.00
3093 4.0 mm .05 lb. $15.00
3094 6.0 mm .05 lb. $15.00
3095 1/8" .05 lb. $15.00
3096 3/16" .05 lb. $15.00
3097 1/4" .05 lb. $15.00
3098 Special Order (.125" - .312") .05 lb. (Allow 3 weeks) $25.00

About Sherline Mill collets...

Sherline milling collets are designed to be used with the Morse #1 internal taper that is standard on both the Sherline lathe and vertical mill. Because of the shallow angle of the Morse #1 taper when the drawbolt is tightened, greater clamping force can be applied when compared to the clamping pressure of WW collets. Therefore, we recommend the use of these milling collets for holding miniature size end mills (3/16" or 1/4" shank), #1 and smaller center drills or DremelĀ® bits (1/8" shank), and assorted other cutters. 

Cutting tools held by these collets must have a shank size within .001" of the manufactured size. Because of the shallow taper angle, these collets will not loosen from the spindle without backing the drawbolt off a couple of revolutions and tapping the drawbolt to free the collet.

Sets Available...

The Sherline milling collet set P/N 3060 consists of a 1/8", 3/16" and 1/4" mill collets, a drawbolt and a thrust washer. (Metric set P/N 3090) includes 3mm, 4mm and 6mm sizes.) Other size collets in inch and metric sizes are also available through Sherline.


RETURN TO ACCESSORIES MASTER LIST

Shop for Sherline LATHES

Shop for Sherline MILLING MACHINES

RETURN TO My Home Page


| Home Page | Frequently Asked Questions | Testimonials | Lathes |
| Mills | Accessories | Tool Prices | Accessory Prices |