Learn Watch Repair

Learn Clock Repair

Learn Lathe Lesson 1 (Turning)

Learn Lathe Lesson 2 (Making Jigs & Fictures)

Back to my Clock, Watch and Lathe Courses


Mill Collet Set

P/N 3060 (inch)

P/N 3090 (metric)

P/N NAME WT. PRICE
3060 Mill Collet Set (inch) 1/8", 3/16", 1/4" .15 lb. $40.00
3090 Mill Collet Set (metric) 3 mm, 4 mm, 6 mm .15 lb. $40.00

About the Mill Collet Sets...

Sherline milling collets are designed to be used with the Morse #1 internal taper that is standard on both the Sherline lathe and vertical mill. Because of the shallow angle of the Morse #1 taper when the drawbolt is tightened, greater clamping force can be applied when compared to the clamping pressure of WW collets. Therefore, we recommend the use of these milling collets for holding miniature size end mills (3/16" or 1/4" shank), #1 and smaller center drills or DremelĀ® bits (1/8" shank), and assorted other cutters. The Sherline milling collet set P/N 3060 consists of a 1/8", 3/16" and 1/4" mill collets, a drawbolt and a thrust washer. (The metric set P/N 3090 includes 3 mm, 4 mm and 6 mm sizes.) Other size collets in inch and metric sizes are also available through Sherline. 

Cutting tools held by these collets must have a shank size within .001" of the manufactured size. Because of the shallow taper angle, these collets will not loosen from the spindle without backing the drawbolt off a couple of revolutions and tapping the drawbolt to free the collet.


RETURN TO ACCESSORIES MASTER LIST

Shop for Sherline LATHES

Shop for Sherline MILLING MACHINES

RETURN TO My Home Page


| Home Page | Frequently Asked Questions | Testimonials | Lathes |
| Mills | Accessories | Tool Prices | Accessory Prices |