Learn Watch Repair

Learn Clock Repair

Learn Lathe Lesson 1 (Turning)

Learn Lathe Lesson 2 (Making Jigs & Fictures)

Back to my Clock, Watch and Lathe Courses


10,000 RPM Pulley Set, P/N 4335

and

10,000 RPM Spindle/Motor/Speed Control Unit, P/N 33070

Left: P/N 4335 10,000 RPM pulley set. Right: P/N 33070 10,000 RPM headstock/motor/speed control

P/N NAME WT. PRICE
4335 10,000 RPM Pulley Set .5 lb. $75.00
33070 10,000 RPM Headstock/Motor/Speed Control Unit 10 lb 335.00

About the 10,000 RPM Pulley Set...

The standard Sherline pulley set is geared to turn the spindle at a maximum speed of 2800 RPM. This offers a speed range sufficient for most lathe and mill operations while taking maximum advantage of the motor's torque. There is a second pulley range that reduces top speed further while increasing torque even more for turning large parts or running slow cutter speeds. However, we often get requests for higher turning speeds from people running small diameter cutters for jobs like engraving. For this purpose we have developed a pulley set that is capable of turning the spindle at speeds up to 10,000 RPM. Naturally, when geared to turn such a high speed, power is somewhat reduced, but this is not normally a problem with small cutters or when turning small shafts. Actually, we have been very impressed with the amount of power that the motor puts out even when running this high speed ratio. (NOTE: To maximize speed and reduce heat buildup Sherline recommends a slightly looser preload setting for turning high RPM. Instructions for adjusting preload are included with the kit.)

The pulley set is installed in about 10 minutes on your Sherline headstock. A new pair of split standoffs replaces the standard hex standoffs, as the new, larger pulley would not fit between the stock standoffs. All other guards and mounting points are retained, and the same belt is used. No special tools or modifications are required. In addition to the 10,000 RPM ratio, a second ratio that offers a maximum speed of about 2200 RPM is included. This is similar to the standard ratio on the normal pulley set for regular machining operations. (NOTE: Because of the split standoff design, changing pulley positions on the high speed pulley set is a little more time consuming than on the standard set, but is still easy to accomplish in just a few minutes.) 

NOTE:  This conversion is only designed for use with the DC motor in use since about 1993. Older AC/DC motors are identified by the smaller speed control housing and cannot be fitted with this pulley set.

10,000 RPM complete headstock available...

If you are purchasing a complete drive unit and need high speed capability, the P/N 33070 is a good choice. It can be installed in your own special tooling application or swapped with the standard Sherline unit on your lathe or mill in just a few seconds. Preload is already pre-adjusted to the proper setting from the factory. 


RETURN TO ACCESSORIES MASTER LIST

Shop for Sherline LATHES

Shop for Sherline MILLING MACHINES

RETURN TO My Home Page


| Home Page | Frequently Asked Questions | Testimonials | Lathes |
| Mills | Accessories | Tool Prices | Accessory Prices |